Specications may change without notice.
347
Solenoid Valves
Description
Technical Features
Symbol
Cross Section
Cavity Details
346
Maximum operating pressure 350 bar
Maximum flow 40 l/min
Maximum internal leakage 0,25 cm
3
/ min @ 350 bar
External component treatment
Zn/Fe - standard (96h)
Zn/Ni (720h)
Switch ON Time 100 ms
Switch OFF Time 50 ms
O-ring Temperature Range -30° C to 110° C (standard sealing NBR - BUNA-N)
Oil Temperature Range -30° C to 110° C
Fluids Mineral - based or synthetics with lubricating properties
Viscosities 7,4 to 420 cSt
Minimum pull-in voltage 85% of nominal
Filtration 20/18/15 ISO 4406 (maximum ltration admitted)
Orientation No restrictions
Installation torque 40 - 45 Nm (Hex. 24)
Technical Specications for characterization see page 480
Oil testing condition ISO VG 46 cSt
Seal kit code SK.031 and SK.027 (coil)
Coil 18W (for more detalis see page 410-425)
Weight 0,125 kg
SVV0.S08 Valve Series
Ordering Code
Flow (l/min)
Pressure (bar)
Performance Details
Technical Data
Note: The performan-
ce chart illustrates flow
handling capacity 1 to 2
(de-energized).
p/Q curves are recorded at
TOil = 40°C and 46 cSt.
SAE08
All external surfaces are zinc plated and corrosion-pro-
of. All valve parts are made of high strength steel. Pop-
pet is hardened and ground to ensure minimal wear and
extended service life. Coil seals protect the solenoid sy-
stem. Manual override option. Industry SAE common
cavity. It replaces the previous SVU0.S08.
Solenoid operated, 2-way 2-positions, normally open, pi-
loted poppet type, screw-in cartridge valve. Typically used
as a blocking or load holding device for high pressure cir-
cuits. When the coil is de-energized, the SVV0.S08 allows
flow from 1 to 2, while flow from 2 to 1 is severely restri-
cted. When the coil is energized the valve closes, blocking
flow from 1 to 2. In this mode, flow from 2 to 1 is allowed
once the pressure overcomes the force of the solenoid.
The rigid design using a 1-piece body contributes to mi-
nimize the effect of eccentricities in cavity and provides
great reliability. Low pressure drop thanks to optimized
flow path.
SAE Cartridge - 350 bar
NO Single Lock Pilot Operated
Poppet Type
NOTE: for more details see page 426-427.
Note: All Solenoid cartridge valves listed in the present catalogue
are designed to work with D.C. power supply. To work with A.C.
power supply, a RAC coil and connector with rectier must be
used. For any additional information, please contact your Sales
contact representative.
( )
